

Intoducing the All New E-Grip, Electronic
Grip System. The E-Grip system uses an electronic control board to activate a selenoid. When activated, the selenoid disengages
the sear, which in turn fires the marker. The System is powered by a concealed 9 Volt Battery. All electronic componets are
completely contained inside the grip, which allows you to quickly and easily change grips.
Fire Modes:
Semi-Auto:
Fires 1 Shot for each trigger pull.
Auto-Response: Fires 1 Shot for each trigger pull or release.
Full
Auto: Fires Repeatedly as long as the trigger is held.
3 Shot Burst: Fires 3 Shots for each trigger pull.
Turbo: Fires 1 shot for every trigger pull, fires 1 shot for every trigger pull or release if the time between
trigger pulls is less than .25 seconds.
The E-Grip Includes: Trigger Assembly, Electronic Componets, and Grip Frame.
The A-5 E-Grip System is available only for the Tippmann A-5
M.S.R.P $150.00



 Introducing the Flatline Barrel
System made exclusively for the Tippmann A-5, 98 Custom and Model 98. This system is now available complete or as a conversion
kit for your existing A-5, 98 Custom or Model 98. The Flatline Barrel System is the first production back spin barrel ever
produced. The principle behind the system is Tippmann's newly designed slightly curved barrel, which applies centrifugal force
to the ball, creating backspin. Not only does this system offer increased accuracy and distance but also offers flat trajectory
for thick brush and canopy play. By minimizing trajectory of the ball and increasing accuracy, you increase the amount of
targets which would ordinarily be out of range. The Flatline Barrel System adds 100 feet of flat trajectory GUARANTEED.
The Flatline Barrel System is available for the A-5, 98 Custom and Model 98
M.S.R.P $149.95
The Cyclone Feed System comes stock on the Tippmann A-5. This Patented Technology increases
the A-5s rate of fire beyond 15 balls per second. Due to systems like the Response Trigger System and the E-bolt Electric
System, Tippmann Markers had the ability to fire faster than gravity could feed paintballs to the marker. The Cyclone feed
system eliminates this problem by pre-chambering the paintballs inside the systems star shaped feed sprocket. The feed sprocket
is then linked to the markers air system. When the marker is fired, the feed sprocket chambers the next ball. Because the
sprocket is linked to the markers firing cycle, the faster you fire the faster the marker feeds. And, since the paintballs
are pre-chambered, you virtually eliminate the possibility of chopping paintballs in the chamber at high rates of fire.
The Cyclone Feed System is available stock only on the all new Tippmann A-5.

 The
Response Trigger System is the ultimate big game fire power. The Response Trigger System increases your trigger speed by resetting
the trigger and sear with excess gas during firing. This gas is used to operate a cylinder behind the trigger to do the resetting.
The pressure of your finger on the trigger pulls it back to fire the next shot. The speed is determined by the amount of flow
through the knurled adjuster on the side. The upper limit on the rate of fire is set by this adjuster.
The Response
Trigger System is available for the A-5, the 98 Custom, and can be retro-fitted to the Model 98 by the Tippmann Proshop. Contact
the Tippmann Proshop for more deatails.
M.S.R.P $99.95


The
Ebolt (electro-pneumatic conversion kit) uses a electronic control board that controls a solenoid valve. The solenoid valve
operates a pneumatic hammer that opens and closes the valve. After being inactive for 10 minutes the system will go into sleep
mode, with an instant awake on the first pull of the trigger.
The Ebolt has the following modes:
Response:
fires on the pull and the release of the trigger Full Auto: 4 to 13 shots per second Turbo: Semi Auto,
goes to response mode if trigger speed is more than 5 times per sec. Burst Mode 1: 3 shot bursts. Burst
Mode 2: 6 shot bursts.
The E-Bolt Electronic System is available for the 98 Custom, and can be retro-fitted
to the Model 98 by the Tippmann Proshop. Contact the Tippmann Proshop for more deatails.
M.S.R.P $295.00

 Due
to the growing demand for Nitrogen/Compressed Air systems we decided to develop a kit that would offer the best efficiency
at a set low pressure. Although the stock 98 Custom will operate on nitrogen without the kit, there is very little advantage
over CO2 because the internals are not designed for a high pressure system. When we design a gun to operate on CO2 we have
to take into consideration a large variety of pressures ranging from an empty bottle all the way up to 3,000psi, where the
rupture disc fails. CO2 changes pressure as the temperature changes, the higher the temperature the higher the pressure. Granted
we cannot cover the entire pressure range, so we shoot for the most common operating pressures. These pressures are 300-2,000psi.
In order to have a gun function through this pressure range, without a large velocity variation, we sacrifice some efficiency
and overall gun comfort. With a high pressure system we are only working with one set operating pressure. Through research
and testing we have found the most efficient pressure to be between 300-400psi. By changing the configuration of the valve
and rear bolt we can obtain better efficiency, less recoil, and a more consistent shot to shot velocity. The new HP kit consists
of a lighter rear bolt, new rear cocking assembly, lighter drive spring, new valve assembly, new vertical adapter, and a low
pressure chamber. With the operating pressure around 350psi the valve opens much easier, but also requires a larger amount
of gas flow to maintain ball velocity. Along with the valve modifications the low pressure chamber supports these flow and
volume demands.A nitrogen bottle and secondary regulator are not included in this kit, but are required. We are offering a
few different styles of both, which can be purchased through our Proshop.
The Comp-Air Low Pressure System is available
for the 98 Custom and the Model 98. The Comp-Air Low Pressure System will be available for the A-5 soon.
M.S.R.P $119.00
|